Little Giant 6EC-CBM 115 Volt, 1/3 HP, 3180 GPH, Manual (No Switch) Epoxy Impregnated Cast Bronze Sump/Effluent Pump for Salty/Briny Water Conditions, 20-Ft. Cord, Bronze, 506812

The Little Giant 506812 6EC-CBM 1/3 hp, 3180 GPH pump is ideal for use as a sump, light effluent, or emergency water transfer pump. The housing is made of epoxy-impregnated cast bronze ideal for briny/salty water conditions or for homes with water softeners emptying into the sump pit. This pump can handle up to 1/2" solids and has a 1.5" FNPT discharge. This pump comes with a 115-volt, 20' cord suitable for standard outlets in North American homes. This is a manual pump - if used as a sump or effluent pump, a switch must be purchased separately.Features & Benefits:- 1/3 horsepower PSC motor- 1-1/2" FNPT discharge- 140 °F (60 °C) liquid temperature ratingPump selection guidelines:Application: effluent pumps can be used to transfer or remove clean water or liquid effluent with up to 1/2" semi-solids. It is not designed to pass raw sewage. Switch options (not all may be available): - Tethered switches rise/drop with the depth of the water. They require a minimum basin size of 18". The on/off levels can be adjusted easily.- Diaphragm switches take up less room than a traditional tethered switch and uses water pressure to turn the pump on/off. A breather tube is located on the plug which must be free of debris for it to operate properly. The on/off levels cannot be adjusted.- Snap-action switches take up less room that a traditional tethered switch. The float rises/lowers with the water level. The on/off level cannot be adjusted. Piggyback vs. integral (built-in):- A piggyback plug allows the switch to be overridden to pump below the off level. It is easily replaceable. - An integral switch is built into the pump. An integral switch cannot be overridden so it is not the best choice for emergency water removal.

• APPLICATIONS: ideal for sump pump, dewatering and water transfer in aggressive water conditions such as briny/salty water or water from water treatment systems; handles up to 1/2-inch solids
• BUILT TO LAST: Epoxy impregnated cast bronze motor housing and cover; nylon impeller; epoxy-coated cast iron volute; Nitrile/carbon/ceramic shaft seal; Polypropylene base; rated for continuous duty
• MANUAL OPERATION: This pump does not come with a switch; if used as a sump pump or effluent pump piggyback switches can be purchased separately
• MOTOR SPECIFICATIONS: Permanent split capacitor (PSC) motor with thermal overload protection; 115 Volts; 60 Hz; 1/3 HP; 600 Watts; 5 running Amps; 14.5 starting Amps
• PUMP SPECIFICATIONS: 3180 GPH at 5-ft. lift; 28-ft. shut-off; maximum 12.1 PSI; 20-ft. cord; 27.8 lbs.